What's new in MITCalc3D for Solid Edge 1.51
Jan 15, 2010
- Integration of Extension Pack EP07 (Plates)
- Integration of Service Pack SP06
- Extended installation options with administrator rights (it is possible to install in the account with administrator rights and start up in all accounts with user rights)
- An example of transmission calculations is available in help (gearing, shafts, bearings, belts, chains...)
- Added support for AutoCAD versions 2010 and 2011
- The below described problems have been solved:
- Calculation of forces and bending moment for spur gear (external, internal, planetary). Everything is newly calculated on an operating pitch diameter. Refinement is related to Ft, Fr and Mo in paragraph [12.0] (Importance - low)
- Refinement of Conversion of Units (Importance - medium)
- Refinement of image switching in the calculation of plates and in the module of technical formulas in Office 2007/SP1. (Importance - medium)
- Refinement of Calculation of Plates - the calculation of rectangular plate, paragraph [4], cases 2 and 9 – wrong recalculation of force. (Importance - high)
- Refinement of the calculation of width between centres (planet/crown wheel) for non-zero backlash in planetary gearing. (Importance - high)
- Refinement of the interface for SolidEdge ST2. (Importance - high)
- Beams, extended range of input cells (dimensions, load...), added IPE Profile. (Importance - low)
- V-belts (SI version): corrected pulley slot angle (SPZ, SPA, SPB, SPC) for selected diameters. (Importance - low)
- Internal gearing ANSI, refinement of the conditioned formatting for bending safety coefficient. (Importance - low)