What's new in PSU Designer II 2.0.4 Build 43
Apr 7, 2017
- Parameters of the source impedance calculators are now remembered between sessions.
New in PSU Designer II 2.0.3 Build 42 (Apr 7, 2017)
- Stepped current tap now reports correctly.
New in PSU Designer II 2.0.2 Build 41 (Apr 7, 2017)
- Stepped current load now shows both values on the schematic.
New in PSU Designer II 2.0.2 Build 40 (Apr 7, 2017)
- Some fixes to help, minimum capacitor value reduced, maximum source impedance increased.
New in PSU Designer II 2.0.2 Build 39 (Apr 7, 2017)
New in PSU Designer II 2.0.1 Build 38 (Apr 7, 2017)
- The width of the results table can now be re-sized.
New in PSU Designer II 2.0.1 Build 37 (Feb 24, 2010)
- A couple of dialog boxes which were re-sizeable now fixed.
New in PSU Designer II 2.0.1 Build 36 (Feb 24, 2010)
- Pressing Enter in the dialog boxes now closes them.
New in PSU Designer II 2.0.1 Build 35 (Feb 24, 2010)
- Error in reporting of stepped current load, now fixed
New in PSU Designer II 2.0.1 Build 34 (Feb 24, 2010)
- Reporting delay now works in seconds instead of milliseconds.
New in PSU Designer II 2.0.1 Build 33 (Feb 24, 2010)
- Suffix for kilo is now "k" instead of "K", which is the correct international convention.
New in PSU Designer II 2.0.1 Build 32 (Feb 24, 2010)
- LC filters were reporting incorrect capacitor and inductor voltages, now fixed.
New in PSU Designer II 2.0.1 Build 30 (Feb 24, 2010)
- Only change is increase in the size of capacitors which can be used to 1F (was 220mF).
New in PSU Designer II 2.0.1 Build 29 (Feb 24, 2010)
- Fixes problems with voltage doublers not producing the correct output with vacuum tube rectifiers