Shuttle-Echo

The Shuttle-Echo VST plugin was developed to be a delay device that focuses on inperfections in the repeats. Especially good for slap-back stuff & wild echo madness (the delay-time can be modulated).

Controls: The MONO-mode does NOT distort the original stereo-image. Each channel has it's own delay-chain, in mono-mode they both use the same settings.

TIME: delay time FEEDBACK: amount of repeats 250 ms/750 ms: maximum delay time

-TIME MOD- This feature modulates the delay time. The slider activates the effect & sets how much the delay time is affected.

SINE/S&H: Selects between a sinewave or sample & hold LFO. (sample & hold changes to a random delaytime value at the rate of the speed control)

-FLUTTER- Pitch modulation effect (applied to the repeats only). The slider activates the effect & sets the mix.

SINE/S&H: Selects between a sinewave or sample & hold waveform. (sample & hold creates random pitch changes at the rate of the speed control)

-FILTER- The slider activates & controls the mix of the filter.

FREQ: Cutoff frequency RES: Resonance HIGHPASS/LOWPASS: Filter-mode

-DRIVE- Overdrive (applied to the repeats only). The slider activates & controls the dry/wet mix.

DRIVE: amount of drive (waveshape) TRHESH: Threshold. This sets the level where the waveshaping occurs (increases volume with high drive settings). PRE FILTER/POST FILTER: puts the drive-section before or after the filter.

MIX: Dry/wet mix